Time resolution of the bunch-shape detector with a thin-wire emission target

The time resolution of a new bunch-length detector based on the radio frequency (RF) scanning of the produced secondary electrons is calculated. A dedicated Monte-Carlo code by means of SIMION software is developed for accurate simulation of spread in the investigated secondary electrons transit times and image width. In calculation the initial energy distribution of electrons and the actual structure of accelerating and focusing electric fields were considered. It is shown that by using a thin-wire emission target a femtosecond time precision could be achieved using moderate applied voltages.     

Improvements on the third generation of electron momentum spectrometer

The significant modifications to our recently constructed electron momentum spectrometer have been implemented. Compared with our previous report, the energy and the angle resolutions are significantly improved and reach △E = 0.45 eV, △θ = ±0.53° and △φ = ±0.84°, respectively. Moreover, the details of data reduction and the relation between azimuthal angle range and the sensitivity are discussed.     

Green and red up-conversion emissions and thermometric application of Er^3＋-doped silicate glass

The green and red up-conversion emissions centred at about 534, 549 and 663 nm of wavelength, corresponding respectively to the ^2H11/2 → ^4I15/2, ^4S3/2 → ^4I15/2 and ^4F9/2 → ^4I15/2 transitions of Er^3＋ ions, have been observed for the Er^3＋-doped silicate glass excited by a 978 nm semiconductor laser beam. Excitation power dependent behaviour of the up-conversion emission intensity indicates that a two-photon absorption up-conversion process is responsible for the green and red up-conversion emissions. The temperature dependence of the green up-conversion emissions is also studied in a temperature range of 296-673 K, which shows that Er^3＋-doped silicate glass can be used as a sensor in high-temperature measurement.     

Electron field emission characteristics of nano-catkin carbon films deposited by electron cyclotron resonance microwave plasma chemical vapour deposition

This paper reported that the nano-catkin carbon films were prepared on Si substrates by means of electron cyclotron resonance microwave plasma chemical vapour deposition in a hydrogen and methane mixture. The surface morphology and the structure of the fabricated films were characterized by using scanning electron microscopes and Raman spectroscopy, respectively. The stable field emission properties with a low threshold field of 5V/μm corresponding to a current density of about 1μA/cm^2 and a current density of 3.2mA/cm^2 at an electric field of 10V/μm were obtained from the carbon film deposited at CH4 concentration of 8%. The mechanism that the threshold field decreased with the increase of the CH4 concentration and the high emission current appeared at the high CH4 concentration was explained by using the Fowler-Nordheim theory.     

Growth and characterization of InAs quantum dots with low-density and long emission wavelength

The growth parameters affecting the deposition of self-assembled InAs quantum dots （QDs） on GaAs substrate by low-pressure metal-organic chemical vapor deposition （MOCVD） are reported. The low-density InAs QDs （- 5 × 10^8cm^-2） are achieved using high growth temperature and low InAs coverage. Photoluminescence （PL） measurements show the good optical quality of low-density QDs. At room temperature, the ground state peak wavelength of PL spectrum and full-width at half-maximum （FWHM） are 1361 nm and 23 meV （35 nm）, respectively, which are obtained as the GaAs capping layer grown using triethylgallium （TEG） and tertiallybutylarsine （TBA）. The PL spectra exhibit three emission peaks at 1361, 1280, and 1204 nm, which correspond to the ground state, the first excited state, and the second excited state of the ODs, respectively.     

场致发射显示器驱动电路研究进展及其性能研究

场致发射显示是一种新型的平板显示技术，场致发射显示器继承了传统的阴极射线管显示器的优良特性，兼有液晶等薄型平板显示器的优点，具有广阔应用前景。介绍了几种不同阴极结构的场发射显示器工作原理及相应的驱动电路，分析并比较了二极管型和三极管型两种场致发射显示器的驱动电路，对新型场致发射平板显示器的理论研究具有参考意义。     

On a current mechanism in Ta2O5 thin films

Electrical conduction in the temperature range of 120–370 K has been studied in sandwiched structures of Al/Ta₂O₅/Si. The tantalum oxide films were prepared by evaporation of tantalum on a p-Si crystal substrate, followed by oxidation at a temperature of 600°C. The temperature-dependent current-voltage (I–V) characteristics are explained on the basis of a phonon-assisted tunnelling model. The same explanation is given for I–V data measured on Ta₂O₅ films by other investigators. From the comparison of experimental data with theory the density of states in the interface layer is derived and the electron-phonon interaction constant is assessed.      

Analysis of additive metals in fuel and emission aerosols of diesel vehicles with and without particle traps

Fuel additives used in particle traps have to comply with environmental directives and should not support the formation of additional toxic substances. The emission of metal additives from diesel engines with downstream particle traps has been studied. Aspects of the optimisation of sampling procedure, sample preparation and analysis are described. Exemplary results in form of a mass balance calculation are presented. The results demonstrate the high retention rate of the studied filter system but also possible deposition of additive metals in the engine.     

Spectroscopic Determination of Oxygen DC Glow-Discharge Temperature: Radial Profile of Gas Temperature

Rotational temperature in the oxygen DC glow discharge is determined from atmospheric A-band of molecular oxygen. Two methods of estimation of this parameter taking into account the quality of the detected spectra are analysed and compared. Radial profile of the rotational temperature is measured. No radial variations of rotational temperature have been observed in the positive column under our experimental conditions.     

Problems of Dust Grains Charging to Negative Potentials

The presence of dust grains is a common phenomenon in the space environment. Grains can be charged by many different processes (e.g., photoemission, attachment of electrons/ions, the secondary emission, etc.). If the grain's surface potential becomes high enough, one can observe field emission of ions or electrons. We are trapping a single dust grain in a Paul trap, expose it to a low-energy electron beam, and investigate the evolution of its charge-to-mass ratio with respect to the energy of primary electron beam. We use micron-sized (D = 2–11 m) glass grains and charge them up to -300 V of surface potentials; it corresponds to the electric field strength of about 10⁸ V/m. Analysis of the charging/discharging processes has shown that (1) the effect of the field enhanced secondary emission is negligible in the case of insulators and (2) the effective work function for electron field emission from charged insulators is as low as 1 eV.